Siemens SIMATIC HMI Operating Instructions Manual page 60

Preface
● WinCC flexible Runtime
● WinCC flexible Migration
– Describes how to convert an existing ProTool project including a change from a
● Communication
– Communication Part 1 describes the connection of the HMI device to SIMATIC PLCs.
– Communication Part 2 describes the connection of the HMI device to third-party PLCs.
Operating instructions
● Operating instructions for SIMATIC HMI devices.
– OP 73, OP 77A, OP 77B
– TP 170micro, TP 170A, TP 170B, OP 170B
– OP 73micro, TP 177micro
– TP 177A, TP 177B, OP 177B
– TP 270, OP 270
– TP 277, OP 277
– MP 270B
– MP 277
– MP 370
● Operating instructions for mobile SIMATIC HMI devices.
– Mobile Panel 177
– Mobile Panel 277
● Operating instructions (compact) for SIMATIC HMI devices.
– OP 77B
– Mobile Panel 177
– Mobile Panel 277
● Operating instructions for SIMATIC accessories
Getting started
● WinCC flexible for first time users
62
Describes how to commission and operate your runtime project on a PC.
– Describes how to convert an existing ProTool project to WinCC flexible.
– Describes how to convert an existing WinCC project to WinCC flexible.
– Describes how to convert an existing ProTool project including a change of the HMI
device, for example from OP3 to OP 73 or from OP7 to OP 77B
graphics device to a Windows CE device.
– Industrial USB Hub 4
Based on an example project, this is a step-by-step introduction to the basics of
configuring screens, alarms, recipes and screen navigation.
Operating Instructions, 09/2007, A5E00471973-02
Industrial USB Hub 4