1 Warning Caution: • Pb free solder has a higher melting point that standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder- ing iron, please be careful not to heat too long.
Page 4
3.2. Trial Operation (after checking Troubleshooting Guide). 3.2.1. Assembly • Confirm if there is no gap between housing A and B by pinching lead wires. • There is no dust or deformation on battery terminals. 3.2.2. Operation • Check that each time the switch is pressed, the mode changes as follows: High mode (maximum luminance) → Middle mode (50% of high mode luminance) →...
4 Disassembly and Assembly Instructions 4.1. How to remove the Handle cover and Long handle assembly 4.2. How to remove the Left lens 4.3. How to remove the LED PCB assembly, Heat release sheet and the Heat- sink assembly.
Page 6
4.4. How to remove the Main module, Switch button and the Switch cover. 4.5. How to remove the while down case and Bottom case.
Page 7
4.6. How to remove the Whirl bracket assembly, Housing AB set, Whirl top case and Sub PCB. 4.7. How to remove the left middle case assembly.