Appendix Parameters - Sony BKMA-7031 Installation Manual

The following parameters are added as the circuit board parameters of the MAV-70 XGI when the
BKMA-7031 is installed.
BKMA-7031 Video Decode Parameters
Parameter Setup Value
. BLANK (Default)
Blank Line
10 to 22 (NTSC) . THROU
7 to 22 (PAL)
Video Gain . 3.0 dB
. 2.8 to _2.8 dB (0.2 dB step)
. _3.0 to _6.0 dB (1.0 dB step)
. _10.0 dB
. _20.0 dB
. OFF (Default : 0 dB)
Chroma Gain . 3.0 dB
. 2.8 to _2.8 dB (0.2 dB step)
. _3.0 to _6.0 dB (1.0 dB step)
. _10.0 dB
. _20.0 dB
. OFF (Default : 0.0 dB)
Black Level . _30.0 IRE
. _29.5 to 29.5 IRE (0.5 IRE step)
. 30.0 IRE (Default : 0.0 IRE)
± 125 us (Default : 0 us)
Sys. Phase Sync
± 50 CK
Sys. Phase Sync (F)
(1/27 us step) (Default : 0 CK)
± 30d (0.23d step. 256 steps in all)
Chroma Phase
(Default : 0d)
Chroma Phase Mode . COMPOSITE : composite mode
. COMPONENT : component mode
. FIELD FRZ F1 : The mode that
Vid Frz Mode
. FIELD FRZ F2 : The mode that
. FRAME FRZ :
Y_add Mode . AUTO (Default)
. OFF
ESR Mode . AUTO (Default)
. ON
VITC Position 1 NTSC 10 to 20 (Default : 16)
VITC Position 2 NTSC 10 to 20 (Default : 18)
VITC Position 1 PAL 7 to 22 (Default : 13)
VITC Position 2 PAL 7 to 22 (Default : 15)
BKMA-7031
Appendix
Parameters
Function
Blanking is turned ON/OFF for each of
the V. blanking lines when BLANK of the video
signal is selected.
(Blanking applies to both the Y/C signal and to
both the odd and even fields at the same time.)
Sets the video gain of the output signal.
Sets the chroma gain of the output signal.
Sets the black level of the output signal.
Sets the sync phase of the system sync.
Performs the fine adjustment of the sync phase
of the system sync.
Sets the chroma phase.
Select the chroma phase modes.
(Default)
Selects the video freeze modes.
freezes the video
signal at the first field
(Default)
freezes the video
signal at the second
field.
The mode that
freezes the video
signal at the video
frame
Selects the Y add modes.
Selects the ESR (Edge Subcarrier Reducer)
modes.
Selects the line to which VITC is going to be
inserted in the NTSC signal.
Selects the line to which VITC is going to be
inserted in the PAL signal.
A-1 (E)