Installation Preparation; Stand Installation; Starting-Up - Silvercrest SEK 2000 B2 Operation And Safety Instructions

Children under the age of 3
are to be kept away from the
device unless they are continu-
ally supervised.
Children between the age of
3 and 8 are only allowed to
switch the device on or off if
they are supervised or given
instructions on safe use and un-
derstand the hazards involved,
provided that it has been
placed or installed in its intend-
ed normal operating position.
Children between the ages of 3
and 8 shall not plug in, regulate,
clean the heater or perform user
maintenance.

Installation preparation


Remove all packaging materials and all transport
bracing from the device.
Check the delivery contents for completeness and
any signs of damage.

Stand installation


1
3
After you have completely unpacked the device,
place it upside down on a clean surface so that
you can fully see the underside (Fig. 1).
Take a stand and insert 3 screws
5
the holes (Fig. 2).
There are 5 holes in each corner of the device.
Now take the stand
place it exactly over the matching holes.
When the screws
4
holes, tighten them with a screwdriver (Fig. 3).
Please proceed in the same way with all four
stands until they have all been assembled.
5
The device can now be placed on its stands
The device is ready for start-up (Fig. 4).
Start-up

Please find a suitable location for the device before
starting it up.
For safe and trouble-free running of the device,
choose an installation location which meets the fol-
lowing requirements:
- The floor should be firm, flat and horizontal.
2
4
through
4
with the screws and
5 4
are inserted in the correct
GB/IE/NI 11
.
5