Table of Contents
Advertisement
Cisco Aironet Four-Port Dual-Band Polarization-Diverse Antenna (AIR-ANT2513P4M-N)
Figure 6
Assembling the Bracket Hardware
5.
Make sure you orient the antenna correctly (note the arrow on the back of the antenna that indicates the top of the antenna).
Use a 1/2 in. (13-mm) wrench to loosen the elevation adjustment bolt and the elevation pivot bolt.
6.
Adjust the azimuth (side-to-side position) and elevation (up-and-down position) of the antenna. Loosen the adjustment
bolts slightly to allow for adjustment. Azimuth angle can be adjusted ±25 degrees and elevation can be adjusted ±60
degrees. You can use the azimuth and elevation markings on the mounting arm and the wall flange as a guide.
7.
After you adjust the antenna position, tighten the adjustment bolts and the pivot bolts. Tighten all bolts to 18.7 +/- 5 lb-ft
(25.4 Nm).
8.
Connect the antenna cables to the access point. The antenna ports are labeled A through D, from left to right.
—
On the AP3702P, connect the antenna port A to connector A on the access point, antenna port B to connector B, and
so on.
—
On the AP1570, connect antenna port A to Port 1 on the AP, antenna port B to port 2 on the AP, and so on.
See the
Suggested Cable
section for cable recommendations.
161
Hide quick links:
Advertisement
Table of Contents
