Bosch Worchester Greenstyle Hanbury 4 Installation, Servicing And User Instructions Manual page 12

Multifuel stove-defra exempt smokeless fuel
Table of Contents

Advertisement

POSITIONING THE STOVE
It is very important to position the multifuel stove as close as
possible to the chimney, and in an area that will favour the most
efficient heat distribution possible throughout the house. The stove
must, therefore, be installed in the room where the most time is
spent and in the most spacious room possible. Recall that these
multifuel stoves produce radiating heat. A multifuel stove also
functions by convection, that is through the displacement of hot air
accelerated upwards and its replacement with cooler air.
The multifuel stove must not be connected to a hot air distribution
system since an excessive accumulation of heat may occur.
DIMENSION
Hanbury 4
J
Stove Width
394mm
K
Stove Depth
325mm
L
Front
225mm min. 225mm min. 225mm min.
M
Back
150mm min. 150mm min. 150mm min.
N
Left
150mm min. 150mm min. 150mm min.
P
Right
150mm min. 150mm min. 150mm min.
Q
Total Width
694mm
R
Total Length
700mm
12
FREESTANDING
HEARTH
Hanbury 5
Hanbury 8
419mm
436mm
341mm
440mm
719mm
736mm
716mm
815mm
Your stove has been tested to applicable international standards
and therefore As a general rule, it is always advisable for a stove to
be installed upon a constructional hearth, but in certain instances
(when only being used to burn wood and not in a recess) it may be
installed upon a 12mm decorative, non-combustible hearth. If the
stove is installed in a recess, such as an inglenook fireplace, the
appliance must be installed on a constructional hearth.
NOTE: The appliance must be installed on floors with an adequate
load-bearing capacity. If an existing construction does not meet this
prerequisite, suitable measures (e.g. load distributing plate) shall
be taken to achieve it.
HANBURY 4 MODEL
WARNING:
burned in the Hanbury 4, this model must be
installed on a constructional hearth.
FLOOR LOADING CAPACITY
WARNING:
the floor is sufficient to carry the weight of the
entire unit, before the stove is installed.
INSTALLATION
If multi-fuel is intended to be
Ensure that the load capacity of
6720819898 C 11/2017

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents