Water Pump Drive Belt; Coolant Draining; Radiator; Cooling Water Pipes Or Hoses - Suzuki Samurai 1986 Service Manual

6-2. .REMOVAL
WARNING:
Check to make sure that cooling water
l
temperature is cold before removing any
part of cooling system components.
Also be sure to disconnect 0 cord from
l
battery 0 terminal before removing any
part.

1. Coolant Draining

1) Remove radiator cap.
2) Loosen drain
its water side.
Fig. 6-6

2. Cooling Water Pipes or Hoses

1) Drain cooling system.
screw on each pipe or hose clip and pull
hose end off.
Fig. 6-7

3. Water Pump Drive Belt

1) Loosen water pump drive belt tension.
2) Remove belt.
4. Cooling Fan, Fan Clutch and Water Pump
Pulley
1) Remove radiator shroud securing bolts
(4 PCS) and cooling fan securing nuts (or
bolts, 4 pcs).
Fig. 6-8
2)Then remove radiator shroud and cooling
fan and/or fan clutch and water pump
pulley at the same time.

5. Radiator

1) Drain cooling system.
2) Loosen water pump drive belt tension.
3) Remove radiator shroud and cooling fan &
clutch at the same time.
4) Disconnect water hoses from radiator.
5) Remove radiator.
.
6-5