Sony DFP-D3000 Quick Start Manual page 13

Wiring of other equipment.
This following is an illustration of the DFP-D3000 rear panel.
To balanced inputs
of booth monitor
OUTPUT
MONITOR OUTPUT
SYSTEM OUTPUT
PHONES
To power amps To phones
and loudspeakers and HI
Note that these D-Sub connectors have metric (M2.5 x .45) jack screw receptacles and require mating
connectors with metric jack screws. A kit of such connectors is provided with each DFP D3000. Do not
use standard D-Sub connectors with 4-40 jack screws.
Cinema processors.
Refer to the list of available Tech Notes in the Appendix of this Guide for instructions on correct audio
and logic interconnections to other cinema processors. Note that Sony connectors use the THX
convention, but other equipment may not. Therefore, pre-fabricated cables or cables made with flat ribbon
computer-type cable are generally not acceptable for use with the DFP-D3000. The DFP-3000 cinema
processor is capable of exceptional performance; do not degrade this by using inferior cables. Sony
strongly recommends that all audio interconnections in your cinema sound rack be made using high
quality audio-grade twisted pair shielded cables or individually shielded multipair cable. Contact your
dealer for information regarding pre-wired audio cables for the DFP-D3000, available from several
cinema accessory distributors.
Non-sync inputs.
The non-sync inputs of the DFP-D3000 are on consumer standard RCA-type connectors. One dedicated
non-sync input is available. If additional non-sync inputs are required, the MIC1 input can easily be
configured for line level operation, and the two eight-channel AUX inputs can serve as additional line
level inputs for electronic projectors, DVD, magnetic film dubbers, and other external analog sound
sources.
Microphone inputs.
The MIC1 and MIC2 inputs have built in microphone preamplifiers, so that external mixers or line-
matching devices are not required to directly connect a microphone level input. Input connections are
balanced on a single D-Sub 9-pin female connector. 48-volt phantom power for condenser microphones is
available, and can be switched on using the setup software or the front panel. See the instructions for MIC
configuration later in this Guide for more detailed information.
DFP-3000
From Mic 1 From Non-sync
and Mic 2 player
INPUT
NON-SYNC
MIC INPUT
R
REMOTE
AUX INPUT 1
CONTROL
AUX INPUT 2 AUTOMATION
From other Automation logic
cinema processors inputs and outputs
From Projector 1 From Projector 1
optical reader R3000 Reader
PROJECTOR I/0
1 READER
L
1 OPTICAL
LEVEL
CONTROL I/0
RS-232C
To laptop PC via
null modem cable
2
2
15V
RS-422
Backup Chassis
supply ground
®
pinout
120 / 230
VAC
3-3