Auto Lead Angle Setting - Toshiba TB6605FTG Reference Manual

Auto Lead Angle Setting

For high efficiency, TB6605FTG needs to be set a lead angle parameter.
When you use a different motor, change a lead angle parameter if necessary.
And also change the TCR parameter for good lead angle value.
Resistor value can be
changed
Usage Notes
To ensure that power supply is at the range of 10V to 28V, and current is under 2A (limited by
‒
Motor spec).
At high current working states, motor and control board may have a high temperature.
‒
Some of the unused pins of the product have not been processed in any way.
‒
Make sure to process these pins as appropriate for your system.
Resistors and capacitors in pin sockets can be changed if necessary when other than the
‒
attached motor is used.
© 2019
Toshiba Electronic Devices & Storage Corporation
Figure 8-5 Auto Lead Angle Setting
29 / 31
RD022-RGUIDE-01-E
2019-Jan-15
Rev.1.0