Error Message - Brother DCP-L8400CDN Service Manual

3.2

Error Message

The error messages displayed on the LCD of the machine and their description are shown in
the table below.
Upper line
Access
Denied
Access Error Press Stop[X].Put
Calibration
Cartridge
Error
Condensation Leave switched
Error Message
Middle line
Function Locked.
Function Locked.
Job Deleted. Press
Stop[X].
the device back in
and try again.
Calibration failed.
Insufficient Toner
for Calibration.
Calibration failed.
Press [Retry], and
try again.
Calibration failed.
Turn the power off
and then back on
again.
Put the Toner
Cartridge back in.
Put the Cyan #C
Toner Cartridge
back in.
Put the Magenta #C
Toner Cartridge
back in.
Put the Yellow #C
Toner Cartridge
back in.
ON. Fully open the
Front Cover. Wait
30 minutes, switch
OFF and close
cover, then switch
ON.
State
In the case of PC-print,
authentication of print restricted
ID failed.
The device was removed during
data was being processed.
Dot counter or develop roller
counter of color toner has
reached the upper limit during
color density adjustment
performed from the control panel.
Density patch measurement
ended unsuccessfully during
color density adjustment
performed from the control panel.
Error occurred with the value
measured during density sensor
sensitivity calibration.
Error occurred with the value
measured during color density
adjustment performed from the
control panel.
The new toner sensor of the
toner cartridge (Black) could not
detect a new cartridge properly.
The new toner sensor of the
toner cartridge (Cyan) could not
detect a new cartridge properly.
The new toner sensor of the
toner cartridge (Magenta) could
not detect a new cartridge
properly.
The new toner sensor of the
toner cartridge (Yellow) could not
detect a new cartridge
properly.
Condensation occurred in the
machine.
2-24
Error Refer
Codes to:
--- 4.14.1
--- 4.14.1
--- 4.14.2
9802 2-72
9803 2-73
9804 2-73
9801 2-72
4F01 2-51
4F04 2-51
4F03 2-51
4F02 2-51
1400 2-46
Confidential