Sony DFP-R3000 Quick Start Manual page 21

Sony recommends that known good SDDS material is always kept in your cinema so
The SYSTEM OK LED on the DFP-D2500 front panel indicates that battery power is OK
that the condition of the playback hardware can quickly be accessed. This will prove
and that the unit is properly communicating with its Reader.
helpful in case there are any doubts about whether poor SDDS playability is caused
by print or hardware issues.
The DATA PRESENT LED will be off until SDDS data is encountered. It will then flash
until a sufficient amount of good SDDS data has been received properly and comes on
solidly when SDDS is played back. If uncorrectable errors cause the system to revert to
the AUX input, the data present LED will again flash. It will not switch to SDDS again
until a significant amount of good SDDS data has been received. Depending on the print
errors, you will find that minimum one of the two SDDS status indicators must be solidly
out of the red area for up to one minute before SDDS playback is again resumed and
the data present LED is again solidly on.
The REMOTE LED indicates that the Decoder is being controlled through its serial port.
The Reader will turn on its bright red reader LEDs when the black sprocket roller is
turning, as long as it is receiving power through its cable. If the DFP-D2500 is powered
and you don't see LEDs on the Reader, check that the Reader cable is plugged in and
has not been damaged.
The EXT FADER button on the front panel of the DFP-D2500 enables a remote fader. If
this function is active (as indicated by its illuminated switch), the MASTER VOLUME
control becomes inoperative and the external fader takes over. Don't use this switch
unless an external fader is actually connected.
In the event you have difficulty. Sony Cinema Products operates service offices
around the world. Contact us for assistance at any of the following locations:
Sony Cinema Products Corporation
Engineering Services Division
West Coast (USA)
10950 W. Washington Boulevard
Culver City CA 90232, USA
Phone: +1 310 244-3484
Fax: +1 310 244-0484
Hours: 8:30am to 5:00pm PST
With 24-hour telephone response
Sony Cinema Products Corporation
Engineering Services Division
East Coast (USA)
123 West Tyron Avenue
Teaneck NJ 07666, USA
Phone: +1 201 833-5778
Fax: +1 201 833-5860
Hours: 8:30am to 5:00pm EST
Sony Cinema Products Europe
Engineering Services Division
Europe, Middle East, Africa
25 Golden Square
London W1R 6LU, England
Phone: +44 207 533 1475
Fax: +44 207 533 1590
Hours: 9:00am to 6:00pm GMT
Sony System Service, Tokyo
Tokki Service Center
Japan
7-22-17 TOC Building 8F
Nishi Gotanda, Shinagawa-ku
Tokyo, 141-0031, Japan
Phone: +81 3 5436 7510
Fax: +81 3 5436 7519
Hours: 9:00am to 6:00pm JST