Mitsubishi Electric A800 Plus Instruction Manual page 20

Removal of the front cover
(a)
(a) With the terminal block cover removed, loosen the screws on the front cover. These screws cannot be removed.
(b) While holding the areas around the installation hooks on the sides of the front cover, pull out the front cover using its upper side
as a support.
(c) With the front cover removed, the control circuit and the RS-485 terminals can be wired, and the plug-in option can be installed.
Reinstallation of the front cover and the terminal block cover
(a)
(a) Clip on the front cover as illustrated.
Check that it is properly secured.
(b) Tighten the screws on the lower part of the front cover.
(c) Attach the terminal block cover using the screws. (The number of screws differs depending on the capacity of the inverter.)
NOTE
• Fully make sure that the front cover and the terminal block cover are installed securely. Always tighten the mounting screws
of the front cover and the terminal block cover.
(b)
Loosen Loosen Loosen
(b)
Removal and reinstallation of the front cover
(c)
(c)
Tighten Tighten Tighten
INSTALLATION AND WIRING
Tighten Tighten Tighten
19
2