Table of Contents
Advertisement
Locations and Functions of Parts and Controls
Rear panel
1 2
7 8 9
1 INPUT 1 (R/R-Y, G/Y, B/B-Y, HD/COMP, VD)
connectors (BNC type)
Connect to the AV switcher to which video equipment,
such as VCRs and video cameras are connected.
2 INPUT 2 (R, G, B, HD/COMP, VD) connectors
(BNC type)
Connect to a computer.
If the computer has a H/V separate sync signal,
connect it to the HD/COMP and VD connectors. If the
computer has a composite sync signal, connect it to the
HD/COMP connector only.
Note
When a computer with a sync signal on G-signal is
connected and an external sync signal is input, the hue
of the images may change. In this case, use the
internal sync signal.
3 SIGNAL OUT connectors (High-density D-sub
15-pin)
Connect to the JumboTron display units using the
JCC-L10/L20/L30 connecting cable (not supplied).
4 CONTROL 1/LS (sensor) connector (D-sub 15-
pin)
Connect to the JTA-LS200 ABC sensor unit using the
specified connecting cable (not supplied). The JTC-
C200 ICU controller can also be connected to this
connector.
10
Locations and Functions of Parts and Controls
Overview
3
4
5 CONTROL 2 and CONTROL 3 connectors (D-
sub 15-pin)
Connect to the JTC-C200 ICU controller.
6 EXTERNAL CONTROL connector (D-sub 15-
pin)
Connect to the power distribution panel of the system,
etc.
7 VIDEO IN connector (BNC type)
This is a composite video input connector.
8 VIDEO OUT connector (BNC type)
This is a loop-through output for the VIDEO IN
connector.
9 MONITOR OUT connector (BNC type)
Connect to the video input connector of the video
monitor.
0 Input/output connector indications
Indicates the location of the input/output connectors at
the right end of the rear panel.
!¡ AC IN connector
Connect to an AC power supply of 100 - 240 V AC.
Use the supplied AC power cord which fits the AC
outlet in your area.
5
6
0
!¡
Advertisement
Table of Contents
