Siemens CP 1243-1 Operating Instructions Manual page 124

Diagnostics and upkeep
6.3 Online functions and TeleService
Note
Transmission time with TeleService
Note that transferring larger amounts of data via WAN (Internet) can take a very long time.
If there are disruptions or interruptions of the transmission path this can lead to the data
transmission being aborted.
Connection establishment to use the online functions via Ethernet
Procedure:
1. Connect the ES to the network.
2. Open the relevant STEP 7 project on the ES.
3. Select the CP or the CPU of the station whose CP you want to update with new firmware.
4. Enable the online functions using the "Connect online" icon.
5. In the "Connect online" dialog, go to the Choose the entry "TeleService via telecontrol" in
the "Type of PG/PC interface" drop-down list.
6. In the "PG/PC interface" drop-down list select the entry "TeleService board".
7. In the table select the CP if it is not already selected.
The path both via the CP or the CPU is possible.
8. Click on the
The "Establish remote connection via telecontrol" dialog box opens.
9. Make the necessary entries in this dialog (see below) and click on "Connect".
Information in the "Establish remote connection via telecontrol" dialog.
In this dialog, enter the data previously configured in STEP 7 under the following headings:
● Telecontrol server / TeleService gateway...
Selection whether the TeleService switching station is located on the PC of the
engineering station or in the network or can be reached via the Internet.
A TeleService gateway cannot be used as a switching station only the telecontrol server.
– Enter the address of the telecontrol server.
– Own server password
124
icon next to the "PG/PC interface" drop-down list.
IP address or name and port number of the telecontrol server that can be resolved by
DNS
Enter the telecontrol password to authenticate the CP with the telecontrol server
The telecontrol password for the CP is configured under "CP identification" in the
security settings, see also the section CP iIdentifcation with the TeleControl Basic
protocol (Page 64).
Operating Instructions, 04/2017, C79000-G8976-C365-03
CP 1243-1