The Lcd Display Cannot Be Viewed Properly - Sony PEG-TJ25 CLIE Handbook (primary manual) Operating Instructions Manual

Clié handheld
Hide thumbs Also See for PEG-TJ25 CLIE Handbook (primary manual):
Table of Contents

Advertisement

My CLIÉ handheld keeps turning itself off
B Your CLIÉ handheld is designed to turn itself off after a period of inactivity (Automatic
power-off). You can set the automatic power-off time by selecting time for [Auto-off
After:] in [General] of the Preferences screen.
b
For details, refer to "Customizing your CLIÉ™ handheld (Preferences): Setting the automatic
power-off time" in "Handbook" (PDF format).
B Did you set [After a preset delay] from [Auto Lock Handheld:] in the Security screen?
If you set [After a preset delay] from [Auto Lock Handheld:], your CLIÉ handheld may
turn off after a shorter period even if you set the automatic power-off time.
b
For details, refer to "Protecting your data with a password: Locking your CLIÉ handheld with
a password (Data protection)" in "Handbook" (PDF format).
My CLIÉ handheld does not produce any sounds
B Is [System Sound:] in [General] of the Preferences screen set to [Off]?
b
For details, refer to "Customizing your CLIÉ™ handheld (Preferences): Setting sounds" in
"Handbook" (PDF format).
B Adjust the volume settings in the Adjust Volume dialog box displayed by tapping
in the Status Info dialog box (page 67).
Tip
If [Muting]* is selected in the Adjust Volume dialog box, all sounds, including audio, are
muted.
* [Muting] is available for PEG-TJ35 only.
b
For details, refer to "CLIÉ™ handheld components: Status Information" (
The backlight does not turn on when I adjust the
brightness level
B If the brightness is set to the lowest level, the display may be illegible. However, this
is not a malfunction.

The LCD display cannot be viewed properly

B Depending upon the angle of vision, the brightness may be uneven, however, this is not
a malfunction. You can adjust the brightness level in the Adjust Brightness dialog
box displayed by tapping
If the backlight is off, you can turn it on by sliding down the POWER/HOLD switch
and hold it for more than two seconds.
(page 65) at the bottom left of the Graffiti 2 writing area.
page 67
).
Continued on next page
• • • • • • • • • • • • • • • • • • • • •
45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Peg-tj35Clie peg-tj35

Table of Contents