Table of Contents
Advertisement
OTHERS CONFIG
M570: REC WITHOUT TELE-F
M571: REC WITH TELE-F
M572: TEMP FILE CREATE
The M572: TEMP FILE CREATE setting page
appears.
4
Rotate the MULTI CONTROL knob to change the
setting.
OTHERS CONFIG
M572: TEMP FILE CREATE
Push SET button
enable: You can create files even after the capacity of
the memory label is exceeded. Files to be created
after the capacity of the memory label is exceeded
are temporary files.
disable (default setting): File creation is disabled
after the capacity of the memory label is exceeded.
5
Press the F5 (SET) button.
The message "Save Complete" appears.
Applying Changes to Basic Network
Settings
After changing basic network settings, you can use M58:
M50-M52 RENEW to apply the changes without
restarting the e-VTR. Proceed as follows.
1
Do steps 1 to 3 of "Basic Network Settings" (see page
9) to display the M5: NETWORK page of the
maintenance menu.
14
Preparations
enable
2
Rotate the MULTI CONTROL knob to bring the
cursor (*) to M58: M50-M52 RENEW and press the
F5 (SET) button.
M5 : NETWORK
M50 : IP ADDRESS
M51 : SUBNET MASK
M52 : DEFAULT GATEWAY
M55 : TAPE LEADER CONFIG
M56 : IP CONFIG
M57 : OTHERS CONFIG
M58 : M50-M52 RENEW
M59 : RESET ALL USER
The M58: M50-M52 RENEW page appears.
3
Rotate the MULTI CONTROL knob to set the setting
to ON.
M5 : NETWORK
M58 : M50-M52 RENEW
ON
Push SET Button
4
Press the F5 (SET) button.
The message "Complete" appears.
M5 : NETWORK
M58 : M50-M52 RENEW
ON
Complete
Advertisement
Table of Contents
