Running The Close-Up By Gesture Application; Real-Time Cropping Application; Preparation Before Setup; Configuring The Real-Time Cropping Application - Sony REA-C1000 Operating Instructions Manual

Set the maximum size and minimum size of the
screen that would be fully occupied by a person
when standing.
Move the four blue circles displayed on the preview
screen to mark the maximum size. Move the four
purple circles displayed on the preview screen to
mark the minimum size.
This is used to distinguish between the difference in
size that occurs between a person standing near the
front and a person standing further away when
viewed from the camera.
6
When finished, click the [Done] button.
The setup is saved in the unit.
Running the Close-up by Gesture
application
Run this application to automatically trigger the zoom
function when a person stands up and to cancel the zoom
when a person sits down.
1
Select [Close-up by Gesture] from
[Applications].
2
Click the [Run] button on the screen.
The run screen appears.
When zoom is active, the normal image is shown on
the right and the close-up image is shown on the left.
Notes
• The close-up operation may not function correctly if
the focus or exposure is not properly set for the
detection area image captured by the camera.
• The close-up operation may not function correctly
depending on the density of people in the detection
area, the size of the person, and the attire of the person.
• The resolution of the close-up output image may be
reduced depending on the resolution of the input
image from the camera and the close-up zoom
magnification.
Real-time Cropping
Application
This application simultaneously displays a wide-angle
view and a cropped view, from a single camera, by
cutting out a desired portion of the whole view in real-
time.
Tip
The Real-time Cropping application can be configured
and run without an option license for the Real-time
Cropping application.

Preparation before setup

1
Connect a camera to the HDMI IN 1
connector, and connect video output
devices to the HDMI OUT 1 and HDMI OUT 2
connectors.
The video input on the HDMI IN 1 connector is
output unchanged from the HDMI OUT 1
connector. The cropped image is simultaneously
output from the HDMI OUT 2 connector. Connect
appropriate devices to each output.
2
Turn on the camera and peripheral devices.
Tips
• Position and configure the camera connected to
the HDMI IN 1 connector beforehand so that the
field of view captures the area to crop.
• A camera that supports 4K (3840×2160) output is
recommended.
Configuring the Real-time
Cropping application
1
Select [Real-time Cropping] from
[Applications].
2
Click the [Setup] button.
The setup screen appears. A preview of the image
from the camera connected to the HDMI IN 1
connector is displayed on the screen.
Note
If the camera image is not displayed, there may be a
problem with the camera connection or settings.
Check the connection and settings again.
29