Further Settings In The Sr35I - Siemens Bewator Entro Series Installation Manual

Installation
8.4.3

Further settings in the SR35i

30
Siemens AB
Security Products
The SR35i offers further menus to adjust the settings. E g to manually set the "ra-
dio channel" to be used or to let SR35i to rebuild its wireless network.
Proceed like this:
1. From the main menu, press 2 for NETWORK SETTINGS.
2. From the Network Settings menu, press 3 for WIRELESS MENU.
There are then four choices: Show install info, RF status, Rebuild network or Alter
settings.
1: SHOW INSTALL INFO
2: RF STATUS
3: REBUILD NETWORK
4: ALTER SETTINGS
*) Important – Service mode
The command Enter Service Mode is used when a SR35i or RF9 is replaced or
moved. It means that the wireless units included in the actual SR35i will "release"
its positions in the network. A new or moved SR35i/RF9 will then directly establish
its position and its "own" units.
If the command is not performed on the old SR35i before the replacement or
movement, there is a risk that it takes long time or units loses their position and fi-
nally searches for another SR35i or RF9.
In practice, a move (or a replacement) of a SR35i could seem to operate – but only
as long as no new search take place (e g at power failure).
Obviously the command cannot be performed on a broken SR35i, but after approx-
imately 60 minutes other units will anyway find the new SR35i.
Displays the installation details (normally only at initial setup).
Displays the current channel used (11-26).
We recommend that this command is performed whenever any unit
has been moved or replaced. This command should be used to re-
build a new radio network for the actual SR35i. This ensures that the
SR35i will find the correct units after e g a power failure.
When the command has been performed verify that all door units are
on-line.
1: AUTO SET CHANNELS :Automatic channel select.
2: MANUALLY SET CHANNELS: Manual set of channel (11-26).
3: ENTER SERVICE MODE / LEAVE SERVICE MODE. Important - see
below*).
03.2014