Accessories Supplied With The Communication Systems Analyzer - Motorola R-2001A Service Manual

Table 2-1.
Equipment
Front cover
Sun shade
Power cord
Oscilloscope probe
In-line wattmeter adapter
Coax adapter
Antenna
Test microphone
Connector kit
Equipment
IEEE-488 Standard
interface bus option
Blower

Accessories Supplied with the Communication Systems Analyzer

Motorola Part No.
15-80335A70
15-80335A55
30-80336A36
RTL-4058A
RTL-4055A
58-84300A98
TEKA-24A
RTM-4000A
RPX-4097A
Table 2-2. Optional Equipment for Use with Analyzer
Motorola Part No.
Consult factory
for retrofit
information.
RTL-4054A
Front panel and CRT protection, storage of cables,
power cord, and other equipment for on-sjte
servicing.
Snap over CRT during use in bright sunlight.
Three conductor cord to supply AC power to unit.
Also used when charging optional battery pack.
A X1 probe with attachments for general servicing.
Allows use of Motorola ST-1200 series in-line watt-
meter elements for direct measurement and display
of forward and reflected transmitted power.
Adapts front panel "N" connector to BNC female.
Plugs into RF in/out connector on front panel with
N to BNC adapter. Used for off-the-air transmitter
and receiver tests.
Used for voice modulation of signals.
Consists of connector shell, clamp, and four
connector pins. Used to fabricate a mating plug for
male dc power connector at back of analyzer.
Enables user to make a dc power cable to inter-
connect separate power source to analyzer. Pins 1
and 2 are positive, pin 3 is the charging line, pin 4 is
ground.
Enables fully automatic testing with the unit
by external control from a computer or
programmable controller.
Provides additional cooling in high ambient
temperature conditions
2-5
Use
Use