16. TECHNICAL DATA....................35 FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
If a tumble dryer is stacked on the top of the washing • machine, make sure to use the correct stacking kit approved by AEG (see more details in chapter "Accessories - Stacking kit"). 2. SAFETY INSTRUCTIONS 2.1 Installation •...
ENGLISH the drum to prevent an internal to be replaced, this must be carried damage. out by our Authorised Service Centre. • Always take care when moving the • Connect the mains plug to the mains appliance as it is heavy. Always use socket only at the end of the safety gloves and enclosed footwear.
It can damage rubber • Disconnect the appliance from the parts of the washing machine. mains electrical and water supplies. Prewash such fabrics by hand before • Cut off the mains electrical cable loading them into the washing close to the appliance and dispose of machine.
Page 7
ENGLISH 5. Put the front polystyrene packaging element on the floor behind the CAUTION! appliance. 6. Carefully put down the appliance Do not use alcohol, solvents with the rear side on it. or chemical products. 9. Make sure to identify the different sizes and the positions of the sound barriers.
Attach the sound barriers at a room temperature. 13. Pull up the appliance in vertical position. We recommend that you keep the packaging and the transit bolts for any movement of the appliance. 3.2 Positioning and levelling 14. Remove the power supply cable and the drain hose from the hose holders.
ENGLISH 4. Connect the water inlet hose to the A correct adjustment of the cold water tap with 3/4" thread. appliance level prevents the vibration, noise and the movement of the appliance when in operation. When the machine is installed on a plinth or if a washer dryer is stacked on the washing machine, use the accessories described in...
Page 10
You can extend the drain hose to maximum 400 cm. Contact the authorized service centre for the other drain hose and the extension. It is possible to connect the drain hose in different ways: 1. Make a U shape with the drain hose and put it around the plastic hose guide.
The tumble dryer can be stacked on the top of the washing machine only by www.aeg.com/shop or from using the correct stacking kit authorised dealer manufactured and approved by AEG. Only appropriate Verify the compatible accessories approved by stacking kit by checking the AEG ensure the safety depth of your appliances.
Page 12
5.2 Fixing plate kit Read carefully the instructions supplied with the accessory. (4055171146) Available from your authorised dealer. If you install the appliance on a plinth, secure the appliance in the fixing plates. 5.3 Appliance overview 11 12 Worktop...
Maximum load indicator. The indicator flashes during the laundry load estimation. Door locked indicator. Delay start indicator. The digital indicator can show: • Programme duration (e. g. • Delay time (e. g. • Cycle end ( ). • Warning code ( Washing phase indicator.
Page 15
ENGLISH 7.2 Introduction If you touch the Start/Pauze button, the appliance performs the spinning The options/functions are phase and drains the water. not selectable with all The appliance empties washing programmes. Check the water out the compatibility between automatically after 18 options/functions and hours approximately.
Page 16
Use this option to add a pre-wash If you select the Cotton phase at 30 °C before the washing programme at 40°C or 60°C phase. and no other options are set, This option is recommended for the display shows the...
ENGLISH 8. PROGRAMMES 8.1 Programme Chart Washing programmes Programme Programme description Washing programmes White cotton and coloured cotton. Normal, heavy and light soil. Katoen Standard programmes for the Energy Label consumption values. According to regulation 1061/2010, the programme Katoen at 60 °C and the programme Katoen at 40 °C with the option are respectively the «Standard 60°C cotton pro- gramme»...
Page 18
Programme Programme description Do not use fabric softener and make sure that Outdoor there is no softener residue in the detergent dispenser. Outdoor clothing, technical, sport fabrics, waterproof and breathable jackets, shell jackets with a removable fleece or inner insulation. The recommended laundry load is 2 kg.
Page 19
ENGLISH Programme temperature, maximum spin speed and maximum load Programme Default tempera- Maximum spin speed Maximum load ture Spin speed range Temperature range Washing programmes 40 °C 1600 rpm 8 kg 95 °C - Cold 1600 rpm - 400 rpm Katoen 40 °C 1200 rpm...
ENGLISH 8.2 Woolmark Apparel Care - Blue The wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as «hand wash» provided that the garments are wash- ed according to the instructions issued by the manufacturer of this washing machine.
11. DAILY USE 11.3 Filling the detergent and WARNING! additives Refer to Safety chapters. 11.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the Aan/Uit button for a few seconds to activate the appliance.
ENGLISH With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit shown on the flap. • Do not set the prewash phase. • Do not set the delay start function.
The programme starts, the lid is locked. In case a selection is not possible, no indicator comes The display shows the indicator on and an acoustic signal The drain pump can operate sounds. shortly before the appliance fills water.
ENGLISH 11.10 Interrupting a 11.13 End of the programme programme and changing the When the programme has finished, the options appliance stops automatically. The acoustic signals operate (if they are When the programme is running, you active). can change only some options: In the display all washing phase 1.
1. If necessary, touch the TPM button to • You do not use the appliance for 5 decrease the spin speed proposed minutes before you touch the Start/ by the appliance. Pauze button. 2. Touch the Start/Pauze button: Press the button Aan/Uit to activate the appliance again.
ENGLISH 12.2 Stubborn stains • Use the recommended detergents for the type and colour of the fabric, the For some stains, water and detergent is programme temperature and the not sufficient. level of soil. We recommend that you pre-treat these 12.4 Ecological hints stains before you put the items in the appliance.
The regular detergents already contain programme Machine Clean. Add a water softening agents, but we small quantity of powder detergent recommend to run a cycle with empty into empty drum, in order to rinse drum and a descaling product out any left residues.
ENGLISH WARNING! • Do not remove the filter while the appliance operates. • Do not clean the pump if the water in the appliance is hot. Wait until the water cools down Proceed as follows to clean the pump: 1. Open the pump cover. 4.
Page 30
11. Put the filter back into the special guides by turning it clockwise. Make sure that you tighten the filter correctly to prevent leakages. 5. When the bowl is full of water, turn the filter back and empty the container.
ENGLISH 45° 20° 2. Remove the inlet hose from the 13.9 Emergency drain appliance by loosening the ring nut. If the appliance cannot drain the water, carry out the same procedure, described in 'Cleaning the drain filter' paragraph. If necessary, clean the pump. 13.10 Frost precautions If the appliance is installed in an area where the temperature can reach the...
Page 32
Authorised Service • - The mains supply is unstable. Centre. Wait until the mains supply is stable. In case of major problems, the acoustic • - No communication between signals operate, the display shows an electronic elements of the appliance.
Page 33
ENGLISH Problem Possible solution • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. The appliance does not •...
Problem Possible solution • Make sure the levelling of the appliance is correct. Refer to The appliance makes an "Installation instruction". unusual noise and vi- • Make sure that the packaging and/or the transit bolts are brates. removed. Refer to "Installation instruction".
Energy Efficiency Class A+++ -20% Spin Speed Maximum 1600 rpm 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 17. ENVIRONMENTAL CONCERNS appliances marked with the symbol Recycle materials with the symbol with the household waste. Return the...