Silvercrest SWR 1166 A1 Operation And Safety Notes page 25

Enter default user name and password
"admin" into both user name and password
blank, then you can enter into next page to reset
user name and password for first setup.
(A user name should consist of at least
8 characters. These should consist of letters with
upper case and lower case as well as optionally
special characters and one or several numbers.
A correspondingly long email address of the user
should be accepted.)
(A password should consist of at least
10 characters. It should contain characters in
upper and lower case, numbers as well as special
characters.)
Enter new user name and password login
again, then enter into setup page:
Click Network - - -> WiFi Repeater,
Click the "ON" button for the WiFi repeater
mode(the default mode is OFF). Select the
network SSID which you want to boost. And then
input the password of the chosen network.
Click "Save/Apply''.
CONNECT AN END DEVICE TO THE WIFI
ROUTER USING WPS
End devices are e.g. PC, mobile phone, tablet
or IP camera. Activate WPS on the end device
according to the manual of the device.
Press the WPS button on the Wifi router button for
less than 3 seconds.
The devices will now connect. After about
2 minutes, the connection works.
Advanced settings:
In the home page, it displays options to change
the settings.
1. LAN Settings
In Network - - -> LAN setup page , you can
set the IP address, DHCP Start/ End IP Address.
GB / IE 25