To enable UPnP in Windows 7:
1. Go to Start Control Panel Network and Internet Network and Sharing Center.
2. On the left pane, click Change advanced sharing settings.
3. On your current network profile, in the Network discovery area, click Turn on network
discovery, and then click Save changes.
Enable IPv6
Select this option and click Save to enable IPv6 settings.
This function only works if your network environment and hardware
Note
equipment support IPv6. The browser should be Microsoft® Internet
Explorer 11.0+, Chrome 71+.
Figure 5-2 Enable IPv6
When IPv6 is enabled, by default, the network camera will listen to router advertisements and
be assigned with a link-local IPv6 address accordingly.
IPv6 Information: Click to obtain the IPv6 information as shown below.
Figure 5-3 IPv6 Information
If your IPv6 settings are successful, the IPv6 address list will be listed in the pop-up window.
The IPv6 address will be displayed as follows:
Configuring Network Settings
45