Table of Contents
Advertisement
5
Insert the new lamp all the way in until
it is securely in place (1). Tighten the
two screws (2). Hold down the
handle to replace (3).
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6
Close the lamp cover and tighten a
screw.
7
Turn the projector back over.
8
Connect the power cord.
The ON/STANDBY indicator around
the I/1 key lights in red.
9
Press the following keys on the
Remote Commander in the following
order for less than five seconds each:
RESET, <, ,, ENTER.
Note
Do not put your hands into the lamp
replacement spot, or not fall any liquid or
object into it to avoid electrical shock or fire.
Disposal of the used lamp
For the custmers in the USA
This product contains mercury. Disposal of
this product may be regulated if sold in the
United States. For disposal or recycling
information, please contact your local
authorities or Electronics Industries Alliance
(http://www.eiae.org).
Replacing the Lamp
39
Advertisement
Table of Contents
