7
UTILITY PACKAGE (SW1DNC-EIPUTL-E)
The setting for each tag is counted as
one setting. Selection of "Not Use" is
not included in the number of settings.
Figure 7.2 How to count the number of auto refresh settings in "Tag Parameter" window
(2) Device ranges of auto refresh
L
M
D
R
B
W
ZR
(3) Terminating Microsoft
7
- 3
7.1 Precautions
POINT
(1) When the number of auto refresh parameter settings exceeds the range of the
QCPU
If the auto refresh is set for each tag, set it on the "Refresh Parameter"
window. (
Or refresh them by a sequence program. (
example of Tag communication)
(2) When the number of auto refresh parameter settings exceeds the range of the
EtherNet/IP module
Set the auto refresh on the "Refresh Parameter" window. (
"Refresh Parameter" window)
Devices can be set within the range shown on the "Device" tab on the "Q Parameter
Setting" window in GX Works2.
Note that other modules and EtherNet/IP modules having a different Nic No. must not
use the same auto refresh target devices.
The following devices can be set with Utility Package.
Table 7.2 Device ranges that can be set
Device
0 to 32752
0 to 61424
0 to 4212735
0 to 32767
0 to EFF0
0 to 4047FF
0 to 4184063
Do not terminate Microsoft
Section 7.9.7 "Refresh Parameter" window)
Setting range
®
®
Windows
®
®
Windows
while running Utility Package.
Section 8.4.1 Program
Section 7.9.7