Transmission Temperature Sensor - Suzuki Baleno Manual

1. Transmission temperature sensor

2. A/T valve body
1. A/T fluid pipe
2. New gasket
TRANSMISSION TEMPERATURE SENSOR
INSPECTION
1) Lift up vehicle.
2) With engine is cool, remove drain plug and drain A/T fluid.
3) Install drain plug. (Refer to "CHANGING FLUID" in this sec-
tion.)
4) Disconnect oil cooler inlet hose (outlet from oil cooler) from
pipe, and remove A/T fluid pipe (lower side).
5) Remove A/T side cover.
6) Disconnect wire harness at coupler of valve body.
7) Warm up transmission temperature sensor. Check resistance
between terminals of coupler at valve body. Thus make sure
its resistance decrease with the increase of temperature.
After inspection, connect coupler.
Temperature
10 _C (50 _F)
110 _C (230 _F)
145 _C (293 _F)
8) Perform steps 71) to 73) of "UNIT ASSEMBLY" in this section.
9) Install A/T fluid cooler hose and pipe, and tighten union bolt to
specified torque.
Tightening Torque
(a): 27 N·m (2.7 kg-m, 19.5 lb-ft)
(b): 18 N·m (1.8 kg-m, 13.0 lb-ft)
NOTE:
Make sure to use new gaskets for A/T fluid pipe union
bolts.
10) Refill A/T fluid.
11) Verify that there is no A/T fluid leakage.
AUTOMATIC TRANSMISSION 7B1-77
Resistance
6.4 kW
247 W
110 W