Table of Contents
Advertisement
Figure 6-1
MARKer Subsystem Syntax Diagram (Cont'd)
Table 6-1
MARKer Parameter Values
Parameter
channel_#
marker_time
lt_arg
gt_arg
inrange_gt
inrange_lt
level
outrange_gt
outrange_lt
V level
type
slope
occurrence
Value
An integer from 1 through 8, depending on how many oscilloscope
cards are installed as a single unit (chained together).
time in seconds from trigger marker to X or O marker
time in seconds that specifies the less than (lt) RUNTil time
time in seconds that specifies the greater than (gt) RUNTil time
time in seconds specifying the lower limit of the INRange runtime
time in seconds specifying the upper limit of the INRange runtime
level in volts that specifies marker position
time in seconds specifying the lower limit of the OUTRange runtime
time in seconds specifying the upper limit of the OUTRange runtime
percentage of waveform voltage level, ranging from 10 to 90 of the
Vtop to Vbase voltage, or a specific voltage level
ABSolute or PERCent
positive or negative slope
integer from 1 to 100
MARKer Subsystem
6–5
Advertisement
Table of Contents
