Basic Setup - ABB ScreenMaster RVG200 Commissioning Instructions

6

Basic setup

Perform the following steps, in sequence, when setting up the
recorder for first-time use – for detailed configuration routines
refer to the Operating instructions (OI/RVG200-EN).
6.1 Start-up
1. Locate and mount the recorder as described in Sections
1 2
and .
2. Make electrical and signal connections as described in
3
Section .
3. Power-up the recorder.
Note. At power-up, a start-up screen is displayed
while a self-test sequence is performed. An operator
view is displayed when the self-test sequence is
complete and the recorder is ready for operation.
4. Proceed to the next step (6.2) to set the date and time.
6.2 Set the date and time
1. Press the Home icon (
to display page 1 of the Operator menus.
2. Press the Configuration icon (
Operator page.
3. Press and at the Operator 1 – Password (0..9999)
page press again (passwords are not set at
first-time use). The Operator 1 Edit / Open / New
configuration page is displayed.
4. Press the Edit Configuration icon
page to display the System Configuration page and press
the Common icon
Configuration level menus.
Time
5. Press the tab and at the Date and time field, press
the icon to display the Date and Time dialog.
Enter the required information in each field, pressing
to accept the content and return to the Date and Time
dialog.
6. When all fields have been set, press
Common Configuration level
6.3 Setup Groups and Channel allocation
Setup
1. Press the tab and at the Number of Groups field,
press and enter the number of Groups required.
Press to return to the Common Configuration
Setup
level.
2. At the Channel Allocation field, press
Group Configuration dialog. Select the channel(s) to be
assigned to each group. When allocation is complete,
press to return to the Common Configuration
Setup
level.
CI/RVG200–EN
) from any Operator or Log view
) to display the Select
at the Operator 1(4)
to display the Common
to return to the
Time
menu options.
to display the
6.4 Set up the archive files
Archive
1. Press the tab to display the associated fields.
2. Press the icon associated with each field to enter
and configure Archive parameters – press
(as appropriate) to accept the content at each field.
3. When all fields have been configured, press
return to the I/O Groups 1(6) page then
the Common Configuration page.
4. Press to exit the Common Configuration level and
return to the System Configuration page.
6.5 Set the sample rate
1. At the System Configuration page, press the Groups icon
to display the I/O Groups 1 (6) page.
2. Press the icon associated with the required Group (for
example ) to display the Group 1 (6) dialog.
Recording
3. Press the
associated with each field to enter and configure
Recording parameters – press
appropriate) to accept the content at each field.
6.6 Select Operator views and Menu enables
1. At the Group 1 (6) dialog, select the view(s) required by
Chart
pressing the
display the associated fields.
2. Press the icon associated with each field to enter
and configure view parameters (Chart / Indicator / Bar)
and Menu enables for each view – press
appropriate) to accept the content at each field.
3. Proceed to the next step (6.7) to set up the archive files.
or
to return to
tab and then the
or OK
Indicator Bar
/ / tabs to
OK
or
OK
to
icon
(as
(as
13