Connection - Sony DSM-T1 Operation Manual

Connection

The illustration below shows a typical connection of
the unit for digital Satellite News Gathering.
• There are two kinds of connectors on the BKSM-T103
Analog Input Board, 3-pin XLR or 5-pin XLR connector.
Satellite link
Rear
Any two
BKSM-T101
SDTI(SX) Input Board
SDTI
IN DIGITAL INPUT
SDTI
to SDTI(SX) output
DNW-A100/A100P
Digital Video Hybrid Recorder, etc.
DVW-A500/A500P Digital Video Cassette Recorder,
DNW-A100/A100P Digital Video Hybrid Recorder,
DNW-7/7P Digital Camcorder with the CA-701 SDI Adaptor, etc.
14
• For more information about connecting external
Low noise block converter
High power amplifier
Up converter
to test signal output
IF OUT REF IN
REF IN
SPARE
IF OUT MONITOR
IF MONITOR
BKSM-T102
SDI Input Board
SDI AUDIO (AES/EBU)
CH 1/2 CH 3/4
IN DIGITAL INPUT
SDI
to SDI output
When using the 5-pin XLR connector, see also the next
page.
equipment, refer to the equipment operation manuals.
SDTI(SX) SDI
equipment equipment
BKSM-R101 BKSM-R102
SDTI(SX) Output SDI Output
Board Board
DSM-R1 Digital Satellite Demodulator
Signal generator
(Sony Tektronix TSG-170A for the
NTSC broadcasting standard, Sony
Tektronix TSG-271 for the PAL
broadcasting standard, etc.)
AC power cord
⁄AC IN
BREAKER ⁄ AC IN
to monitor input
Spectrum analyser
When using the 3pin XLR connector
BKSM-T103
Analog Input Board
VIDEO AUDIO
VIDEO AUDIO CH2
CH1 CH2
IN ANALOG INPUT
AUDIO CH1
to analog
to analog
composite video
audio output
output
(channel 1 or 3)
BVW-75/75P Video Cassette
Recorder, etc.
Analog
equipment
BKSM-R103
Analog Output
Board
to signal output
to a wall outlet
to analog
audio output
(channel 2 or 4)
to reference
signal input