3.2 Creating New Group and Gateway
2. Setup Wizard (1/6):
a.
Type the Name of the Gateway.
b.
Click "BV1250GW" in the "Unit" list,
"V1.62" in the "Version" list, and "BRIT-
QSIG" in the "Interface" list.
Note: Do not select any other value than
above.
c.
Type the Comment for the Gateway.
d.
Click [Next >].
3. Setup Wizard (2/6):
a.
Type the IP Address, Subnet Mask, and
Route Address of the Gateway.
Example for Los Angels office:
•
IP Address: 200.45.11.35
•
Subnet Mask: 255.255.255.0
•
Route Address: 200.45.11.1
b.
Click [Next >].
4. Setup Wizard (3/6):
a.
Type the "Call control signal TCP port
no." (default: 1720).
Note: Use the default value unless there
is a known network conflict.
b.
Click [Next >].
5. Setup Wizard (4/6):
a.
Do one of the following:
•
Click the "Use Default Password"
check box to accept the default
Maintenance Level Password
("mainte").
•
Clear the "Use Default Password"
check box, then type and confirm
the new password to change the
default password.
b.
Click [Next >].
Getting Started
25