Kenwood NX-200 Service Manual page 7

3. Remove the coaxial cable from the GPS PCB.
Note: When you remove the coaxial cable from the GPS
PCB, remove perpendicularly to the GPS PCB.
4. Remove the GPS PCB from the connector (CN710) of
the Control PCB.
5. Affi x the terminal of the coaxial connector to the fi brous
sheet (G11-1362-04) as shown in the fi gure.
INSTALLATION
Coaxial cable
Coaxial connector
GPS PCB
Coaxial cable
Fibrous sheet
(G11-1362-04)
6. Fold the fi brous sheet (G11-1362-04) in half, and cover
the terminal of the coaxial cable as shown in the fi gure.
Coaxial cable
Fibrous sheet
(G11-1362-04)
7. Insert the fibrous sheet into the slit of the holder as
shown in the fi gure.
NX-200(G)
7