Configuration
The GPIO switches have two positions: Logic High (left position, marked with "H") and Logic
Low (Right position, marked with "L"). When setting a switch to "H" (default position), the
GPIO line is not connected (uses the internal G24 pull-up resistor), when setting the GPIO to "L",
the line is being shorted to ground.
Caution:
UID - S170
The UID S170 switches are used for development purpose only and should remain at OFF (left
position) for proper use of the G24.
Figure 2-16
S170 component.
Figure 2-16: S170 Switches
26
In order to avoid unnecessary load on one of the GPIO lines, verify that when a
GPIO line is configured as an output and is set to logic High state, the
corresponding GPIO switch is set to "H".
shows the UID switches provided on the Developer Board, which are located on the
Developer's Kit
April 1, 2006