Epson S5U1C33001H Manual page 10

S5U1C33001H
Power-Supply Operation Section
• Power switch
This is the power switch of the S5U1C33001H. The S5U1C33001H turns on when this switch is set to the "I" position.
• AC power connector
Plug the AC cable in this connector.
• USB connector
This connector is used to connect a USB cable.
Target System Interface Connectors
• 10-pin target system interface connector
The target system is connected using the 10-pin or 10 to 4-pin cable.
• 30-pin target system interface connector
The target system is connected using the 30-pin cable.
Note: Use one connector only from either the 10-pin or 30-pin target system interface connectors.
• Target system power supply connector
This connector can supply power and output a reset signal to the target system using the 6-pin cable.
10
(Ver. 4)
O I
AC input connector Power switch
Figure 10 Power-Supply Operation Section
• • • • • •
Target system power supply connector
Figure 11 Target System Interface Connectors
Rear panel
USB connector
Side panel (Left)
• • • • •
• • • • •
Target system interface connectors