Canon Finisher-R1 Installation Procedure page 25

53 2mm
F-1-29
2) Check the tilt of the finisher and its host machine.
Check to make sure that the gap between the upper
cover of the finisher and the delivery cover of the host
machine is 3±1.5 mm. Take measurements at 2
locations (front and rear), and check to make sure that
the gap at the front and the rear is 1.5 mm or less. Also,
check to be sure that the gap between the finisher and
its host machine is parallel from top to bottom when
viewed from the front.
53 2mm
3) If the height/tilt is correct, end the installation work
by referring to "Work After Making Checks/
Adjustments." If the height/tilt is not correct, see the
instructions in "Adjusting the Height/Tilt."
Chapter 1
3 1.5mm
F-1-30
17