Prepare Data Base; Initial Data Application - Bosch MS 6 Manual

4.1.1 Basic Engine Data
4.1.2 Crank- and Camshaft Wheel
Bosch Motorsport

4 Prepare Data Base

Using RaceCon, the data base is already generated and the modification may start imme-
diately. For information, please see RaceCon manual.
ModasSport uses the two MS 6 programs MS6a_xxxx_yyyy_data.s19 and
MS6a_xxxx_yyyy_ms_a2l for work folder generation.
For help, please follow the Modas Sport manual instructions.

4.1 Initial Data Application

The following chapter deals only with the main parameters which should be checked be-
fore a first engine startup. Several functions are recommended to be switched off, many
software labels will not be explained in detail. To work on these functions and labels after
the first startup, please refer the full-scope function description. The offline data applica-
tion guide shall help to get the engine started the first time without problems.
CAUTION
Wrong engine setup data may lead to serious engine damages.
The MS 6 system can be used for engines up to 12 cylinders. Please ensure that the cor-
rect software variant is loaded in your ECU. Define the engine parameters like number of
cylinders, firing order, injection system and cam- and crankshaft designs in relation to
TDC.
The system initially supports wheels with 60-2 teeth. Other configurations in the limits
between 30- and 60 teeth may be possible to configure also. Please refer also to the
chapter Ignition Trigger Wheel [} 23].
Main Data Labels to configure for crank- and camshaft wheel
CRANK_TOOTH_CNT
CWINTF_CRANK
CRANK_GAP_TOOTH_CNT
CAM_MODE
CAM_TOOTH_CNTx
CAM_POS_EDGESx
CAM_NEG_EDGESx
ANG_CAM_CATCHx
SYNC_CAM
Engine_Control_Unit_MS_6.x_Manual
Number of teeth of the flywheel (including the missing
teeth) (limited to 30-60 teeth)
Selection of used crankshaft sensor type (Hall or induct-
ive type)
Number of missing teeth on the flywheel
Camshaft position detection mode
Number of teeth on the camshaft
Position [°CRK] of positive camshaft edges
Position [°CRK] of negative camshaft edges (online
measurement, see channels cam_neg(pos)_edges_xxx)
Max. deviation of cam edges angles allowed
Camshaft signal used for engine synchronization
Prepare Data Base | 4
33 / 76