Front Brake Disc Check; Rear Brake Shoe Check - Suzuki GA413 Service Manual

FRONT BRAKE DISC CHECK

Refer to BRAKE PAD INSPECTION of this section for inspection
point and procedure.
FRONT BRAKE PAD LINING CHECK
Inspect pad linings periodically according to maintenance sched-
ule whenever wheels are removed (for tire rotation or other rea-
son). Take a look through each end (or hole) of caliper and check
lining thickness of outside and inside pads.
If lining is worn and its thickness ("d" in figure) is less than limit, all
pads must be replaced at the same time.
Thickness "d"
Service limit: 1.5 mm (0.06 in.)
1. Pad rim
2. Disc
3. Lining

REAR BRAKE SHOE CHECK

1. Rubber plug
2. Brake lining
Inspection should be carried out on following points after brake
3. Brake shoe rim
pedal travel (pedal to wall clearance) check, even when pedal trav-
el is normal.
Amount of brake shoe wear can be checked as follows.
1) Hoist vehicle.
2) Remove rubber plug from brake back plate.
3) Through hole of back plate, visually check for thickness of brake
shoe lining. If lining thickness "e" is found less than limit, replace
all shoes with new ones at the same time.
Thickness "e"
Service limit: 1.0 mm (0.04 in.)
BRAKES 5-15