Advertisement
To Connect The
Data Bus:
Figure 6
Location Of Connectors On The CC-5
SPECIFICATIONS
Siemens Industry, Inc.
Building Technologies Division
The Data bus connectors on the cardcage motherboard are P1 and P2. (Refer to
Figure 6.) They are 60 pin, keyed, male connectors with connector extractors.
1.
Open the connector ejectors out of the vertical position and away from the
connector body.
2.
Insert the female cable connector into the male connector (P1 or P2) on the
cardcage motherboard. Gently press the cable connector into the
motherboard connector. As the cable connector is pressed in, the connector
ejectors will begin to move to the vertical position. When the cable connec-
tor is fully seated the connector ejectors will be vertical.
Physical Specifications:
Electrical Ratings:
See PSC-12 Installation Instructions, P/N 315-099321, and the PSX-12 Installation
Instructions, P/N 315-048553, for complete power supply loading calculations.
CONNECTOR EJECTORS
IN VERTICAL POSITION
10.58"W x 14.25"H
The PSC-12 supplies the power to the two 60-pin Data
bus connectors (P1 and P2) in the CC-5. The total
rating for all CC-5s in any given enclosure is as follows:
24 VDC,
2 Amps max
6.2 VDC,
2 Amps max
5
P/N 315-099319-4
Advertisement
