Kenwood NX-5800 Service Manual page 90

Item Condition
Panel tuning
mode
[NXDN 1) Adj item:
Very [Nv NDEV]
Narrow] Adjust:[****]
2) Adj item:
[Low1]→
[Low3]→
[Low5]→
[Center1]→
[Center3]→
[Center5]→
[High2]→
[High4]→
[High6]
Adjust:[****]
PTT : ON
Press [ ] key to
store the adjust-
ment value.
17. QT 1) Adj item:
Devia- [Aw QT]
tion *3 Adjust:[****]
Deviation meter
[Analog LPF: 3kHz
Wide HPF: OFF
5k] 2) Adj item:
[Low1]→
[Low3]→
[Low5]→
[Center1]→
[Center3]→
[Center5]→
[High2]→
[High4]→
[High6]
Adjust:[****]
PTT : ON
Press [ ] key to
store the adjust-
ment value.
1-90 (No.RA017<Rev.003>)
Measurement
PC test mode Test-
equip-
ment
1) Adj item: Devia-
[NXDN High Devia- tion
tion (NXDN Very meter
Narrow] Oscil-
Deviation meter lo-
LPF: 3kHz scope
HPF: OFF
2) Adj item:
[Low1]→
[Low3]→
[Low5]→
[Center1]→
[Center3]→
[Center5]→
[High2]→
[High4]→
[High6]
Press [Transmit]
button.
Press [Apply All]
button to store the
adjustment value.
1) Adj item: Devia-
[QT Deviation (An- tion
alog Wide 5k)] meter
Deviation meter Oscil-
LPF: 3kHz lo-
HPF: OFF scope
2) Adj item:
[Low1]→
[Low3]→
[Low5]→
[Center1]→
[Center3]→
[Center5]→
[High2]→
[High4]→
[High6]
Press [Transmit]
button.
Press [Apply All]
button to store the
adjustment value.
Unit Ter- Unit Parts
minal
Panel ANT Panel [Panel
tuning
mode]
[],
[]
[PC
test
mode]
[←],
[→]
Panel ANT Panel [Panel
tuning
mode]
[],
[]
[PC
test
mode]
[←],
[→]
Adjustment
Method
Write fixed value for 1311~1363Hz
each adjustment point.
(The value is written be- [PC test
low.) Transmit at each mode]
adjustment point and Press [Apply
check that the deviation All] button to
is between 1311Hz and store the
1363Hz. adjustment
Deviation meter value after all
LPF: 3kHz adjustment
HPF: OFF points have
been adjusted.
505
[Panel tuning mode]
PTT: ON
[PC test mode]
PTT: Press [Transmit]
button
Write the value as fol- 0.75kHz±0.05
lowings. kHz
521
Specifica-
tions
/Remarks