Advertisement
2. Remove the paper tray.
2.1 Remove the blue knob A of the transfer corotron cleaning
rod.
2.2 Pull the knob B, remove and clean the waste toner container.
Put it back into place.
2.3 Remove the two plastic clips C, holding the pick up and feed
rollers. Remove the rollers, clean them with rubber cleaning
fluid from the accumulated paper dust and dirt and inspect
the surface for wear. A normal surface should be rough, if
not replace the rollers. Reassemble the rollers.
2.4 Inspect the color of the separation roller D. The color is an
indicator of the age of the roller. A new roller should be
blue. For some strange reason they tend to become green as
they age. Note - if you have problems with double sheet
feeding and the color is green, you know what to do. See
figure 4.
B
3. Main body of the machine
3.1 Remove the wire A by squeezing it in B. Remove screw C
and pull out the process unit. See figure 5.
3.2 Remove screw A and the cover B of the registration
assembly. Underneath unplug one connector and remove a
screw.
3.3 Remove screw C and pull out the 6
with window cleaner as well as the mirror itself.
3.4 Push gently the tab D and carefully remove the
transfer/separation corotron assembly.
3.5 Remove the registration assembly by pulling it out in
direction E. See figure 6.
A
C
D
C
A
th
mirror cover. Clean it
4
3.6 Gently remove the ozone filter A in the direction B and clean
it with vacuum cleaner.
3.7 Remove screw C, remove the cover D and remove the screw
underneath. Note – note the hole the screw is fitted in (there
are two holes –a round one and a prolonged one the right is
the round). See figure 7.
5
3.8 Remove screws A and the exit/fuser cover.
3.9 Unplug connectors B, C and D and remove the fuser unit by
pulling it out in direction E. See figure 8.
B
A
C
E
D
B
B
A
D
C
E
C
B
D
6
A
7
8
Advertisement
