Information On Insulation Tests, Protection Class And Degree Of Protection - Siemens SIMATIC IFP2200 INOX MT ETH Compact Operating Instructions

Technical specifications
5.5 Ambient conditions
Emission of radio interference
The following table shows the emitted interference from electromagnetic fields according to
EN 61000-6-4, measured at a distance of 10 m.
Radiated emission (emitted interference)
1 GHz to 3 GHz
3 GHz to 6 GHz
30 MHz to 230 MHz
230 MHz to 1000 MHz
Emission of radio interference voltages
0.150 MHz to 0.5 MHz
0.5 MHz to 30 MHz
5.5.4

Information on insulation tests, protection class and degree of protection

Test voltages
Insulation strength is demonstrated in the type test with the following test voltages in
accordance with IEC 61131-2:
Circuit
Rated voltage U
Ethernet connector
Protection class and degree of protection
The device offers the following protection against foreign bodies and water:
Feature
Protection class
Degree of protection, front
Degree of protection, rear
The IP degrees of protection and enclosure type can only be ensured if the mounting seal is
in full contact with the cutout. Read the corresponding information in section
"Notes on installation (Page 16)".
Degree of pollution / overvoltage category according to IEC 61131
● Degree of pollution 2
● Overvoltage category II
40
< 66 dB peak and < 46 dB average
< 70 dB peak and < 50 dB average
< 40 dB (μV/m) quasi-peak
< 47 dB (μV/m) quasi-peak
< 79 dB quasi-peak and < 66 dB average
< 73 dB quasi-peak and < 60 dB average
Insulation tested with (type test)
24 V 707 V DC or 500 V AC to other circuits / to ground
e
1500 V AC
Standard
EN 61131-2
EN 60529
ISO 20653
EN 60529
Degree
Protection class III
IP69
IPX6K
IP20
Touch protection test with standard test probes.
There is no protection against ingress by water.
Compact Operating Instructions, 03/2018, A5E42185570-AA
IFP2200 INOX MT ETH