Table of Contents
Advertisement
Installation of this unit
≥ Rail check: pattern 2
Gap
under 1.0 mm
(0.04q)
Put the fixture in the rail connection part
of the gear rack on the drawer side, then
slide from right to left to check.
OK
Under 1.0 mm
(0.04q)
≥ Error flow chart
If there was an error in checks in patterns
1 and 2 (gaps of 1.0 mm (0.04q) or more)
1 Release the connection of the gear
rack. (
34)
2 Remove the M5 screws from the two modules.
3 Open the module halfway and pull out.
4 Redo the tasks starting from
"Installing in the rack" (
Gap under 1.0 mm (0.04q)
Use the washers supplied with the
Bottom Module to readjust the front and
back of the module and perform the
installation (
right) so that the gap
becomes under 1.0 mm (0.04q).
Installation
Error
1.0 mm (0.04q) or more
Refer to the
following "Error
flow chart".
25).
OK
Error
ACCEPT
Readjust the forward-backward module position
If the joints connecting to the gear racks are too far from
their proper forward-backward position, insert the supplied
M5 washers between the mounting brackets and the racks
to adjust the forward-backward module position.
Keep the extra M5 washers in a safe place in case they
are used when modules are added.
10
Attach the bottom panel.
≥ Firmly tighten the four screws.
32
M5 washer
Advertisement
Table of Contents
