Operation With a FreFlow® Wireless System
Wait with the power switch set to ON. You do not need to make any special operations. Operation will start automatically when a wireless signal is received.
Light color will change by wireless command only in a venue where a FreFlow® wireless system is set up. Light color may not change when used in a venue other than that where the product was
purchased. This does not indicate a malfunction.
If you turn the power switch to ON in a location without wireless signals, the LED will light up.
After Use
If the battery is exhausted or if you will not use the device for a long period of time, remove the battery as shown below.
Extend the belt, and then slide it out in either direction indicated by the arrows.
Remove the two screws on the bottom with a screwdriver, and then open the cover.
Remove the battery from the battery box.
<Improper use of batteries may lead to leaking, excessive heating, rupture, or damage. Please follow the cautions below.>
When inserting the battery, set it with the + and – terminals in the correct direction.
Do not use or leave in places with intense direct sunlight or in hot locations such as a car in the sun.
Use a new battery when replacing the battery.
Do not subject a battery to fire or high temperatures.
Tape over battery contacts to avoid short-circuit when disposing of a battery, and follow local regulations for battery disposal.
Specifications
Model Number: FFS-W
Materials
Light part: ABS / Belt: Silicon and steel
Power Requirement
Size AAA (LR03) alkaline battery: 1.5 V DC
Battery life
Approx. 3 hr. *
1
*
1
Time may vary, depending on the temperature or conditions of use.
MADE IN VIETNAM
FreFlow® and its logo are trademarks or registered trademarks of Sony Engineering Corporation.
Screws
FFS-W
UW-000