ABB Totalflow microFLO G4 Startup Manual page 7

Step 5 Solar Panel
The solar panel is designed for outdoor mounting on a 2" extension pipe
and is installed on the upper end of the µFLO
solar panel must be mounted within 12 feet of the µFLO
is wall-mounted, the solar panel can be mounted on the top or side of the
meter house.
Note: Electrical wiring must be installed according to requirements for
the area classification. For further information, refer to the
certification drawing indicated on the device's name tag and
national
codes.
Note: Do not connect the solar
panel power cable to the
G4
µFLO
battery pack has been
connected to J15 and
the J16
been set across pins 1
and 2.
5A Attach the 2-inch pipe
to the top end of the
µFLO
pipe. Securely tighten.
Install the pipe
extension into the
coupling. Upon
completion, tighten.
5B Install the solar panel onto the mounting bracket with the
corresponding hardware. Attach the mounting plate to the top
end of the extension pipe. Do not tighten until the solar panel
has been correctly positioned. For northern hemispheres,
position the solar panel facing south. For southern
hemispheres, position the solar panel facing north.
Note: Do not connect the other end of the solar panel to the µFLO
until instructed to do so.
5C Remove the CHGR Input terminal block (J17) from the µFLO
board. Insert the solar panel power cable through the access
hole. Allow enough cable for field wiring to the CHGR Input +/-
terminations on J17. Trim the wire ends back ¼".
5D Loosen the terminal block securing screws, and insert the wire.
Upon completion, retighten. Connect the solar panel (+) lead to
the (+) terminal and the (-) wire to the (-) terminal. Verify the
main battery pack is connected and that the J16 jumper is set
and local
unless the main
jumper has
G4
mounting
G4
40" mounting pipe. The
G4
. If the µFLO
G4
G4
G4
5