Starting The Remote Ui - Canon imageRUNNER 2545i Remote Ui Manual

Starting the Remote UI

To start the Remote UI, follow the procedure below.
1
Start your web browser.
2
Enter the appropriate URL into [Address] or [Location] bar in the
web browser ➞ press the [ENTER] key on your computer
keyboard.
http://<the IP address of the machine>/
If you do not know the appropriate URL, consult your network administrator.
The Remote UI top page is displayed.
IMPORTANT
• The IP addresses shown in the screen shots and text in this manual are for illustrative
purposes only.
• If the Language Switch setting is set to 'On', some characters are restricted and
cannot be entered. To enter all characters, set the Language Switch setting to 'Off'.
(See Chapter 3, "Configuring the Machine's Basic Settings," in the Reference Guide.)
• If you change the language on the Remote UI, the characters of the displayed
language can be entered. However, if the displayed language is different from the
language used on the touch panel display of the machine, the language may not be
displayed correctly.
• To enter characters from a web browser, use the characters that you can enter from
the machine's control panel. If you use other characters, they may not be displayed or
recognized properly on the machine.
NOTE
You can change the language displayed on the Remote UI top page by clicking the
[Language] drop-down list box and selecting the desired language, regardless of the
language used on the touch panel display of the machine.
3
Enter your ID and password depending on the management mode
applied to the machine.
The required ID and password vary depending on the management mode
(Department ID/User Management) applied to the machine. For more information, see
"Enabling Department ID Management and User Management," on p. 3-2.

Starting the Remote UI

1
1-9