• "Installation Guidelines" on page 30
2. Turn off the corresponding DWC tray that you are going to perform the task on.
3. Remove the tray (see "Install a DWC tray in the enclosure" on page 63).
4. Remove the tray cover (see "Remove the tray cover" on page 34).
Complete the following steps to remove an adapter.
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BHNs9o9uS9u93aeU5BCI8I
• Youku:
http://list.youku.com/albumlist/show/id_51372950.html
Step 1.
Remove two silver Torx T10 screws; then, remove the retaining clamp.
Figure 26. Screws and retaining clamp removal
Step 2.
Carefully grasp the PCIe riser-cage assembly by its edges and remove it out of the node.
.
Chapter 3
Solution hardware setup
41