7.10.2 Update; 7.10.3 Configuration - Siemens DOME COLOUR CFMC1315-LP Configuration Manual

7.10.2 Update

7.10.3 Configuration

Siemens Building Technologies
Fire Safety & Security Products
You can update system firmware once the update file is available. It is the
customer's responsibility to update firmware. All camera motions will shut down
during firmware update. Close any other screens before starting a firmware update.
Never disconnect power and LAN cable during the firmware update process.
Rebooting the camera after firmware update may take approx. 15 minutes.
The power supply to the camera must not be interrupted during the SW update.
Otherwise the camera will be damaged and have to be returned to the workshop
SIGNALWORT
for repair.
Camera configuration information can be exported and saved to a personal
computer. It can also be imported from the personal computer to network cameras.
Export – Click on "Export" button and choose a file directory to save file in your
computer.
Import – Click on "Import" button and select the configuration setting file to start
importing file to your network camera.
Factory Default – Clicking the Default button in the setup screen; the
configuration Information resets all values to factory default.
NOTE
Basic network settings will not be reset.
Network camera reboot – Click the Reboot button and a the confirmation
message "This will reboot the camera. Are you sure?" will be displayed. Click
"OK" to reboot the network camera.
Configuration
53
01.2009