The data cable (2) is permanently attached to the monitor. It has a 15-pin D-SUB connector for the
screen controller of the system unit.
See your PC's operating manual for details of the ports on the system unit.
Ê
Connect the 15-pin connector of the data cable to the (active) monitor port on the system unit
and secure the plug-in connection by tightening the safety screws.
If your system unit has two monitor ports ("onboard" screen controller and separate
i
graphics card), the monitor port for the separate graphics card is usually active.
Ê
Plug the power cable supplied into the power connector (1) of the monitor.
Ê
Plug the power cable into the monitor connector at the rear of the system unit.
Ê
Plug the power connector of the system unit into a properly grounded power outlet.
When you start working with your monitor for the first time you should install the
i
appropriate graphics drivers for your application software. Details of how to do this are
provided in the documentation on your screen controller/the associated driver software.
Operation of the monitor
A26361-K609-Z100-2-5E19
1 = Control panel with buttons for the OSD
1 2 3
2 = Power indicator
3 = ON/OFF switch
menu (On-Screen Display)
Color monitor 175V
English - 9