Installation Instructions; Outdoor Vertical Drawers Care; General Cleaning - KitchenAid 780-0016 Installation Instructions And Use & Care Manual

1. Remove the drawers from mounting frame by:
Fully extend the empty drawer

Push up the one release lever while pushing down on

the other release lever.
Pull the drawer outward until it is released from the

drawer slide.
2. Install mounting frame flush to the face of the cabinet
cutout. Make sure the mounting frame is level.

OUTDOOR VERTICAL DRAWERS CARE

IMPORTANT: For routine cleaning, wash with soap and water using a soft cloth or sponge. Rinse with clean water and dry at
once with a soft, lint-free cloth to avoid spots and streaks.
Do not use steel wool to clean the product, as it will scratch the surface.
STAINLESS STEEL
IMPORTANT: To avoid damage to stainless steel surfaces, do
not use soap-filled scouring pads, abrasive cleaners, cooktop
polishing creme, steel wool, gritty wash cloths or paper towels.
Cleaner should not contain chlorine. Damage may occur.
Spills may cause permanent discoloration.
Cleaning Method:
Rub in direction of grain to avoid scratching or damaging

the surface.
Stainless steel cleaner.

 Liquid detergent or all-purpose cleaner.
 Rinse with clean water and dry with soft, lint-free
cloth.
Vinegar to remove hard water spots.

Glass cleaner to remove fingerprints.


INSTALLATION INSTRUCTIONS

General Cleaning

3. Install screws (not supplied) into holes located on the
mounting frame.
4. Re-inserting the drawers by:
Extend the drawer slides.

Insert the brackets on each side of the drawer into

the slots in the slides, being careful that they are
properly positioned.
Once properly inserted, completely close the drawer

to set the slides in their proper positions.
EXTERIOR and INTERIOR
The quality of this material resists most stains and pitting,
providing that the surface is kept clean, polished and covered.
Cleaning Method:
Apply stainless steel polish to all areas before first use.

Reapply after each cleaning to avoid damage.

Cleaning should always be followed by rinsing with clean,

warm water.
Use a metal polish or stainless steel brightener to remove

fingerprints, water spots, oxidation, and food stains.
Always follow the manufacturer's directions.
 Wipe the surface completely dry with a soft cloth.
9