Kenwood KRK-14H Service Manual page 4

(3) Fit the KRK-15B with four tabs onto the front of the chassis.
(Fig. 3)
Note:
When installing the KRK-15B onto the front of the chas-
sis, hold down the flat cable with your fingers to prevent
it from being caught.
2.1.6 Install the KRK-14H onto the NX-5700, NX-5800 or
KCH-19 operation panel
(1) Insert the cable attached to the interface unit (XC3-0080-
20) of the KRK-14H into the display unit connector (CN2)
of the panel.
(2) Insert the flat cable attached to the interface unit of the
KRK-14H into the display unit connector (CN6) of the pan-
el. (Fig. 4)
(The two cables have been pre-inserted in the connector
(CN35, CN37) of the KRK-14H.)
Operation Panel
CN2
Note:
The blue line of the flat cable and the flap of connector
are as same side.
After inserting, the flat cable should be locked with the
connector (flap) surely.
(3) Fit the four tabs of the KRK-14H into the operation panel.
Note:
Fit so that the flat cable towards the way of the arrow us-
ing a finger. (Fig. 5)
Operation Panel
KRK-14H
1-4 (No.RA021<Rev.001>)
Fig.3
CN6
KRK-14H
Fig.4
Fig.5
2.1.7 Connect the KRK-15B and KRK-14H with the KCT-71
(1) Insert one lead wire with connector of the KCT-71 into the
connector (CN3) of the KRK-15B. (Fig. 6)
KRK-15B
CN3
KCT-71 lead wire with connector
(2) Secure the cable bush as shown in the figure 7 and attach
the dust cover.
Note:
There is a direction to the installing of the cable bush.
Dust Cover
(3) Slide the molding cover so as not to float the dust cover and
attach so that it is locked. (Fig. 8)
Molding Cover
(4) Insert the other lead wire with connector of the KCT-71 into
the connector (CN1) of the KRK-14H.
(5) Attach the dust cover and molding cover in the same way
of step 2 and 3.
Fig.6
Cable Bush
Fig.7
Fig.8