Traverse Function - Toshiba TOSVERT VF-S15 Instruction Manual

1． Introduction
The VF-S15 has a traverse function useful especially for textile machines.
The manual explains about the traverse function.
Please read this instruction manual carefully along with the VF-S15 instruction manual.
2． Parameters for setting the

traverse function

The parameters in Table 1 are used for traverse operation shown in Figure 1.
Table 1: Traverse function setting parameters
Title





Note: To perform traverse operation, you need to assign the traverse permission
signal 134 (135 [inverse]) to an input terminal.
The settings of the above parameters ( to ) take effect once in
every half cycle of traverse operation.
Output frequency (Hz)
Reference
frequency
RUN command
Traverse permission
Function
Traverse selection
Traverse acceleration time 0.1~120.0 (s)
Traverse deceleration time 0.1~120.0 (s)
Traverse step
Traverse jump step
Traverse frequency (Hz) = Reference frequency (Hz) ×  (%)
Peak jump frequency (Hz) = Traverse frequency (Hz) ×  (%)

During operation
Fig. 1: Traverse operation
Adjustment range
0:Disabled
1:Enabled (Note)
0.0~25.0%
0.0~50.0%
 
ON
2
E6581877
Default setting
0
25.0
25.0
10.0
10.0
Peak jump frequency
Traverse frequency
Traverse frequency
Peak jump frequency
Time (sec.)