Cable Binding; Connector Attachment; Table 15. Recommended Minimum Allowed Cable Bending Radius - Samsung 310 5G CPE Installation Manual

•
•
The table below provides the recommended minimum allowed cable bend radius
of different types of cables.

Table 15. Recommended Minimum Allowed Cable Bending Radius

No Cable
1 Ground/Power Cable
2 UTP Cable
※ If the allowed cable bending radius is specified by the m anufacturer, com ply with the bend radius specified.

Cable Binding

This process involves fixing and arranging an installed cable using binding thread,
cable ties, binding wire, and ram clamps.
Follow these guidelines when binding a cable.
•
•
•
•
•

Connector Attachment

This process involves assembling a connector to an installed cable or to a device
on the site.
Follow these guidelines when attaching the connector.
•
•
•
5G CPE Outdoor Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
If the cable needs to be protected, use a suitable protective cover such as a
PVC channel, spiral sleeve, flexible pipe, and cable rack.
Install the DC power cable and the data transmission cable away from the AC
power cable to prevent electromagnetic induction.
Allowed Cable Bending Radius
• Operation: 8 × OD
• Installation: 12 × OD
4 × OD
Be careful not to damage the cable during binding.
Use proper cable binding tools according to the target location (indoor or
outdoor) and the type of the cable (power supply cable, optical cable, or feeder
line).
Ensure the cutting sections of the cable tie and the binding line are not exposed
to the outside. This may cause damage to the cables or personal injury.
Cut off the remainder of the cable thread by leaving about 50 mm of extra
length to prevent the knot from easily getting untied.
If there is a chance of contact-failure to occur in the connector connection due
to tension, bind the cable at the closest location to the connector.
Ensure operator is fully aware of the connector assembly method before
assembling the connector. Assemble the connector in accordance with its pin
map.
Each connector has a hook to prevent its core positions from being changed.
Check the corresponding grooves before connecting the connector to another
connector.
Confidential
Chapter 3 Connecting Cables
33